|
This kit is a complete water feature kit and consists of a bucket (resevoir) which is set into the ground. A large base plate which fits over the bucket to collect the water, and channel it back to the bucket. The pump with fittings to suit the stone or feature. The water is recycled back to the bucket and pumped up into the stone or feature via the hose supplied. You will need to dig a hole for the resevoir bucket, then place the pump in, add the base plate which goes at ground level.
Add your chosen feature, fill with water and switch on. The pump has an adjustable flow so you can vary the amount of water delivered and the base plate is generally best covered with pebbles, Snowdonia or paddlestones which look great when wet. It will take 2-3 hours to install and will need the electrics to be connected by a suitably qualified person.
The water feature kit plate is 760mm in diameter. The sump is 400mm deep and 400mm in diameter. It sits beneath the water collecting plate.
It is only suitable for 600mm monoliths and below, Pyramids (all sizes) and boulders or sawn boulders. For monoliths above 600mm we would recommend a substantial grid or heavy duty sump. | 
